1. TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH

(a) Temporarily install the suspension upper arm with the 2 washers, bolt and nut.

HINT:

After stabilizing the suspension, tighten the nut.

2. INSTALL FRONT FENDER APRON SEAL REAR LH

(a) Install the apron seal with the 5 clips.

3. INSTALL FRONT FENDER APRON SEAL LH

(a) Install the apron seal with the 6 clips.

4. CONNECT STEERING KNUCKLE LH

(a) Connect the steering knuckle to the suspension upper arm.

(b) Install the nut and a new cotter pin.

Torque: 110 N·m (1122 kgf·cm, 81 ft·lbf)

NOTICE:

If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.

5. CONNECT SKID CONTROL SENSOR WIRE

(a) Connect the sensor wire to the steering knuckle and upper arm with the 2 bolts.

Torque: 13 N·m (133 kgf·cm, 10 ft·lbf)

Torque: 29 N·m (296 kgf·cm, 21 ft·lbf)

8. TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH

(a) Tighten the nut.

Torque: 235 N·m (2396 kgf·cm, 173 ft·lbf)

13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT